LAVAMAT BELLA 3452NWashing machineUser information
10Overview of termsThe English terms used in this User Information booklet correspond to the German/Italian names below that are to be found on your a
11Before the first wash1. Open the detergent drawer.2. Pour approx. 2 litres of water through the detergent drawer into the washing machine. This clos
12Running a washing cycleOpening the door/loading washing1. To open the door: pull the door by the handle.When the machine is switched on, the DOOR li
13– the washing’s degree of soiling,– the size of the load– the degree of hardness of the water supply. • If the manufacturer does not give instructio
14Switching on the appliance/selecting a programmeSet the programme and tempera-ture using the programme knob. 3 By selecting a programme, you switch
15Selecting the programme optionsIf desired, press the programme op-tion button(s). The corresponding light lights up. 3 If “Err” flashes in the multi
16Setting the delay timer3 With the DELAY TIMER button you can postpone the start of a pro-gramme by 30 minutes (30') to a maximum of 23 hours (2
17Interrupting a programme/adding washingInterrupting a programme• A washing programme can be interrupted at any time by pressing the START/PAUSE butt
18Child safety deviceWhen the child safety device is set, the door can no longer be closed.Setting the child safety device: Use a coin to turn the kno
19Cleaning and maintenanceImportant! Do not use furniture care products or aggressive cleaners to clean the appliance. Wipe control panel and body wit
2Dear customer,Please read this User Information carefully and keep it to refer to at a later date.Pass this User Information on to any subsequent own
20Door and rubber collarRegularly check whether deposits or foreign bodies are present in the folds of the rubber collar or on the inside of the glass
21E10 appears.END indicator flashes 1x, at the same time an acoustic signal sounds 1x.(Problems with water inflow.)Tap turned off. Turn the tap on.Fil
22E20 appears. END indicator flashes 2x, at the same time an acoustic signal sounds 2x.(Problems with water outflow.)Kink in the drain hose. Remove ki
23If the wash results are not satisfactoryWashing is grey and scale is being deposited in the drum• Too little detergent is being used.• The right det
24Carrying out an emergency drain1 Warning! Before emergency draining, switch off the washing machine and remove the mains plug from the socket.Warnin
25Drain pumpThe drain pump is maintenance-free. It is only necessary to open the pump cover if there is a malfunction and water is no longer being pum
26Disposal2Packaging materialThe packaging materials are environmentally friendly and can be recy-cled. The plastic components are identified by marki
27Technical data5This appliance conforms with the following EU Directives:– 73/23/EEC dated 19.02.1973 Low Voltage Directive– 89/336/EEC dated 03.05.1
28Installation and connection instructions1 Safety information for the installation• This washing machine cannot be built-in.• Before using for the fi
29Installing the applianceTransporting the appliance1 Warning! The washing machine is very heavy. Risk of injury. Be careful when lifting.• Do not lay
3ContentsOperating Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Safety . . . . . . . . . . . . . . . . . . .
302. Remove the power supply cable and the draining hose from the hose holders on the rear of the appliance.3. With a suitable spanner unscrew and rem
315. Remove the bracket D.6. Tighten up the six smaller bolts C.7. Open the porthole and remove the polystyrene block fitted with the ad-hesive tape o
32Connect the water inlet hose as described under the paragraph “Water inlet”.Where to installImportant! The appliance must not be used in a room wher
33Connecting to the water supplyPermitted water pressureThe water pressure must be at least 1bar (=10N/cm2=0.1MPa) and may be a maximum of 10bar (=100
344. Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. Installation should comply with local water author
35Water drainageThe maximum permitted difference between the height of the surface on which the appliance is installed and the water outlet is 1 metre
36Guarantee/Customer ServiceServicestellen5506 Mägenwil/ZürichIndustriestrasse 10 Points de Service1028 PréverengesLe Trési 6 Servizio dopo vendita691
37www.electrolux.comp t bAlbania +35 5 4 261 450 Rr. Pjeter Bogdani Nr. 7 Tirane Belgique/België/Belgien +32 2 363 04 44 Bergensesteenweg 719, 1502
38 Slovenija +38 61 24 25 731Electrolux Ljubljana, d.o.o.Tržaška 132, 1000 LjubljanaSlovensko +421 2 43 33 43 22 Electrolux Slovakia s.r.o., Electrol
39ServiceIn the event of technical faults, please first check whether you can remedy the problem yourself with the help of the operating instruc-tions
4Installation and connection instructions. . . . . . . . . . . . . . . . . 28Safety information for the installation. . . . . . . . . . . . . . . . .
www.electrolux.com132 978 810-00-150806-01 Subject to change without notice
5Operating Instructions1 SafetyPrior to using for the first time• Follow the ”Instructions for installation and connection”.• If the appliance is deli
6• Switch off the washing machine before cleaning, maintenance and servicing. In addition, pull the mains plug out of the socket or – in the case of a
7Description of the appliance Control panel Detergent dispenserdrawerScrew feet (height adjustable)Plinth flap/Drain pumpRating plate(behind door)Cont
8Programme overviewProgrammemax. load 1) (dry washing) 1) A 10 litre bucket contains approx. 2.5 kg dry washing (cotton)Additional programmes Spin spe
9Application/FeaturesCaresymbols1) 1) The figures in the care symbols indicate the maximum temperatures.Energy-saving programme which washes at 60 °C
Kommentare zu diesen Handbüchern