AEG Electrolux EHG 679 B Betriebsanleitung Seite 17

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 28
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 16
Maintenance
3.3 Cleaning the Dirt Trap
A wire-mesh sieve is located in the intake port of the
pump to act as a dirt trap for coarse particles. It should
be kept clean to avoid a reduction of the pumping speed.
For this purpose, remove the dirt trap (2/2) from the inta-
ke port and rinse it in a suitable vessel with solvent. Then
thoroughly dry it with compressed air. If the dirt trap is
defective, replace it with a new one.
The cleaning intervals depend on the appli-
cation. If the pump is exposed to large amo-
unts of abrasive materials, a dust filter
should be fitted into the intake line.
3.4 Removing and Fitting
the Internal Demister
Required tools:
Allen keys 5 mm and 8 mm.
The internal demister is spring-mounted in a frame.
When it is clogged, it rises periodically to reduce the
pressure difference created.
The resultant noise at high intake pressures indicates
that the internal demister is dirty.
Periodically clean or replace the internal demister; the
maintenance interval depends on the application. Use a
suitable solvent for cleaning.
Shutdown the pump and drain the oil (see Section 3.2).
Pull the handle upward.
Remove the five recessed screws (10/5) on the oil case
(10/1). Don’t remove the non-recessed screws; they hold
the motor flange in place.
Pull the oil case forward off the pump.
Remove the gasket (10/7).
Press the spring buckles (10/2) sideways away from the
frame (10/4). Lift off the frame (10/4) and remove the
internal demister (10/3).
Clean all parts and check that they are in perfect condi-
tion; if not, replace them with new parts.
Reassemble in the reverse order.
Torque for the screws (10/5) is 5 Nm.
17
GA 01.202/9.02 - 03/96
Attention
Attention
Fig. 10 Removal and fitting of the internal demister
Key to Fig. 10
1 Oil case
2 Spring buckles
3 Demister
4 Frame for demister
5 Hex. socket screws (5 pcs.)
6 Silencing nozzle
7 Gasket
Seitenansicht 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare